Planar PE1900 User Manual download pdf (Page 26)

Troubleshooting

This chapter contains information about how to troubleshoot your LCD Monitor. If you have tried

all of the items listed below, please contact qualified service personnel.

A. My display doesn’t work, even though the computer appears to work.

1. Make sure the power cable is securely plugged into the display.

2. Make sure the display is turned on.

Try turning the display off and then turning it on again.

Make sure the display’s power cord is plugged into a power outlet and into the AC power

adapter. Check to see whether the outlet works by plugging another device (such as a lamp)

into the outlet. (If the light on the front of the display is lighted, it is getting power. Try the

next item on this procedure.)

Check the cable connection between the display and the computer. The cable connectors must

be pushed in all the way.

B. The message “Check Cable” appears on my display.

This message appears when the video cable is not properly connected to the computer.

1. Make sure the analog video cable is plugged into the Analog Video Input port on the back of

the display.

2. Make sure the other end of analog video cable is plugged into the PC’s video port.

C. The message “No Sync” appears on my display.

This message appears when there is no video signal from the computer with cable already

connected.

1. Make sure that the computer's power is turned on.

2. Make sure that your graphic card is appropriately set-up.

D. The message “Signal Out Of Range ” appears on my display.

This message appears when the input signal is beyond the display's capability.

Set your PC to a supported video mode, preferably 1280 x 1024 at 60 Hz. See “Setting the Video

Mode” on page 8.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

No comments

Planar PE1900 User Manual Page 26