Planar PR6020 User Manual download pdf (Page 13)

English

Setting Up

Warning Indicator

 When the “LAMP” indicator lights solid red, the projector

will automatically shut itself down. Please contact your local

reseller or service center.

 When the “TEMP” indicator lights solid red for about 60

seconds, it indicates the projector has been overheated. The

projector will automatically shut itself down.

Under normal conditions, the projector can be switched on

again after it has cooled down. If the problem persists, you

should contact your local dealer or our service center.

 When the “TEMP” indicator lights solid red, it indicates the

fan failed. Please contact your local dealer or our service

center.

Powering Off the Projector

1. Press the “Power” button to turn off the projector lamp; you

will see a message

displayed on the projector’s screen. Press the “Power” but-

ton again to conrm, otherwise the message will disappear

after 5 seconds.

Please note that if the key is pressed instead, the projector

will enter the “Hide” mode and no image will be displayed.

To exit the “Hide” mode, press the “Power” button again.

2. The cooling fans continue to operate for about 20 seconds

for cooling cycle and the Power LED will turn green. When

the Power LED begins ashing, the projector has entered

standby mode.

If you wish to turn the projector back on, you must wait

until the projector has completed the cooling cycle and has

entered standby mode. Once in standby mode, simply press

“Power” button to restart the projector.

3. Disconnect the power cord from the electrical outlet and the

projector.

4. Do not turn on the projector immediately following a power

off procedure.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

No comments

Planar PR6020 User Manual Page 13