Planar PD7170 User Manual download pdf (Page 36)

Installation

22 Planar PD7170 Installation/Operation Manual

PREL

MINA

5. Press and hold the lens release

button. Then, grasp the lens by the

front and rotate it

counterclockwise until it stops

(approximately 30 degrees).

6. Pull the lens straight out to remove it.

7. Remove the trim ring attached to

the motor housing on the lens you

just removed. To do this, remove

the two screws and two metal

clips that hold it in place.

8. Attach the trim ring to the motor

housing on the new lens.

9. Note that the lens mount flange

has a female socket connector for

the lens motor on the right side of

the flange. (The lens assembly

motor has a male socket

connector that mates with this

connector.)

10. Hold the replacement lens assembly with the motor facing to the right.

Carefully insert the back of the lens assembly into the hole in the lens flange.

11. Slightly rotate the lens assembly counterclockwise to align the motor

connectors on the lens and lens flange. Gently push the lens assembly in

until it is seated flush against the flange and the motor connectors have

seated.

12. Carefully rotate the lens assembly clockwise until it stops and the metal clips

at the back of the lens “click” into place.

13. Replace the projector front cover.

Trim Ring

Lens Motor

Connector

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 99 100

No comments

Planar PD7170 User Manual Page 36